MULTISIM FUNCTION GENERATOR GENERATOR
The signal generator waits for the specified trigger to start waveform generation. Trigger source-Specifies the trigger source.Selecting an Immediate trigger starts waveform generation as soon as all configuration settings are applied. Trigger type-Specifies the type of trigger to use for starting waveform generation.Using this control allows the signal generator to produce the correct output signal for the most common applications: high (>1 MΩ) load impedance or matched output and load impedance. Load impedance-Specifies the load impedance.Output impedance-Specifies the output impedance of the signal generator.Start phase (deg)-Specifies the horizontal offset of the standard waveform.For example, to configure a waveform with an amplitude of 10.00 V to range from 0.00 V to +10.00 V, This value is the offset from ground to the center of the waveform. DC offset (V)-Specifies the DC offset of the standard waveform.For example, to produce a waveform ranging from -5.00 to +5.00 V, set Amplitude (Vpk) to 5.00. This value is the amplitude at the output terminal. Amplitude (Vpk)-Specifies the amplitude of the standard waveform.This value is the percentage of time the square waveform is high in a cycle. Duty cycle (%)-Specifies the duty cycle of the square waveform.Frequency (Hz)-Specifies the frequency of the standard waveform.Type-Specifies the standard waveform for the function generator to produce.Function Setup-Configures the characteristics of the function to generate.Stop generation-Use this mode to stop a continuous generation that was started by another instance of this Express VI that was configured to Start generation.To stop the generation, drop another instance of the Express VI on the block diagram, select the same signal generator, and configure it to Stop generation. In this mode, the Express VI returns immediately after starting the generation. Start generation-Configures the signal generator to generate the waveform continuously and starts the generation.
![multisim function generator multisim function generator](https://img.youtube.com/vi/CeOl6EzD-_c/sddefault.jpg)
Generation Mode-Specifies the generation mode of the signal generator.Disable output on close-Specifies the behavior of the output enable relay when the device resources to the selected signal generator are released.ĭisabling the output grounds the output connector otherwise, a constant DC voltage representing the last data point generated before stopping the waveform may be present.If you re-open the VI and the selected signal generator is dimmed, it is no longer available. This ring control lists all NI signal generators installed on this computer that can be used by this Express VI. Device-Specifies the signal generator used.